Material Handling Instruments

Pyrotech Provide best range of belts way switch with effective & timely delivery.

• Mechanical flag indication for pull cord switch
• Mounting Bracket
• Operating Position 1 – 0 – 1

• E.O.T. Cranes, Loaders, Tipplers, Conveyors, Transfer Cars, Elevators, Mills, Mobile Cranes, Material Handling Equipments etc.
• Belt Conveyors,

Low Speed Switch is designed to evaluate the speed of a rotating object based on the speed information picked up by the non-contact type Inductive Proximity Switch.

• Non-contact sensing.
• Linear dial markings for speed setting (Trip Point control).
• Input sensor selection facility: NPN or PNP or 2 Wire DC (NAMUR) type proximity switches can be used.
• Monitor (Cast Aluminium for field mounting type) is dust and water tight to IP-65 grade.
• Sensor is dust and water tight to IP-67 grade.

• To sense under speed or over speed conditions.
• Interlocking of conveyors.
• Motion detection.
• Fan speed monitoring.

Pyrotech's Limit switches, are designed to work as limiting devices. The switch is typically snap-action and designed to sense the presence, absence, or be triggered by an excess or lack of physical contact at the position where it is installed.

• Heavy duty enclosure for dusty industrial use
• Special tubular silicon gasket
• Standard Cast Al. / DMC / Cast Iron or Flameproof enclosure
• Retaining type stainless steel screws
• Heavy duty contacts

• The switch allows smooth running of the conveyor and protects it from damages by over swaying

Pull Cord Switch is designed as an emergency switch to instantly stop the belt conveyor when an accident resets (snap action). 

• Cast aluminum enclosure.
• Rationalized design and construction allow the interchangeability of parts.
• Special rubber seal (O ring ) on the shaft for better protection against ingress of dirt, dust, etc.

• Automatic Assembly Line,
• Emergency Stopping Device